Step I - Always start your makeup with a clean, dry face. If you need moisturizer under the makeup, make sure it is water-based type, as it will be absorbed in the skin faster and will not leave an oily coating on the face. If applying makeup to several people we recommend scooping a small amount of makeup out and putting it on a palette, this will help prevent the spread of germs.
Step 2 - Place Grand Opening and .38 Exit appliances on your face to find proper fit. Hold the appliance in place, add some powder on a powder puff and pat it around the edges of the appliance. Remove the appliance and you should have an outline of the area the appliance will cover. You may need to trim off some excess edges first. If you choose, you can make a small hole in the appliance and pull Worms through them, to hang down, or go from one wound to another. This will help support the weight of the worm. Otherwise glue them to your face as with any other appliance.
Step 3 - Using the applicator brush in the cap of the Spirit Gum, apply it to the area on the skin that the appliance will cover. Using you index finger or the appliance, tack up the Spirit Gum by tapping it repeatedly. When you see “threads” coming off your face, the Spirit Gum is tacky. Press the appliance into the Spirit Gum. Using a powder puff, pat powder around the edge of the appliance to remove any stickiness caused by excess Spirit Gum.
Step 4 - Mix Zombie Rot thoroughly before using by adding 2-3 tablespoons of hot water to each container. If it is too thick, slowly add water until proper consistency. Let cool slightly to avoid burns from the hot water. Scoop out a small amount and spread it out evenly onto the skin. DO NOT get Zombie Rot in any hair. Continue spreading Zombie Rot into irregular shapes. You can fill gaps with makeup. Zombie Rot can also be used to hide the edges of the appliances. If you need to build up material for a strange 3-D effect, a simple technique is to work a small amount of cotton into the Zombie Rot before it dries. Once it is dry, cover with more material. Allow the Zombie Rot to dry for 2 or 3 minutes and then you can pick at the surface to create holes in the material. Once done with this phase, dry the material more thoroughly with a hair dryer on a cool setting.
Step 5 - You are now ready to apply the forensic green makeup. Draw a Makeup Sponge across the top of the makeup and begin to apply it to the skin with a patting motion. Apply makeup on top of the Zombie Rot and to the face, neck, hands and any other exposed areas.
Step 6 - Next use the black makeup to shadow or push back areas such as under the eyes to give a sunken look, to fill holes picked in the Zombie Rot, and other areas you want to look deep set. Black makeup may also be used on the lips. If any black lines are too harsh, stipple a thin layer of base over them with your sponge.
Step 7 - You can use a brush to detail your makeup. A brush can also be used in place of a sponge to apply makeup in tight spots, like around the eyes.
Step 8 - For added effect, you can add a Woochie Bald Cap and some facial hair. A good option is to add Cinema Secrets Blood Gel to some of the holes in the face and add Cinema Secrets Rotten Teeth or Temporary Tooth Stain.
Removal - To remove all makeup, use soap and warm water, however it is best to use the Cinema Secrets Makeup & Adhesive Remover. Put a small amount into your hand and using the pads of your fingertips, massage into makeup. Work in circular motions, being careful not to get any in your eyes or mouth. If some should get in your eyes, flush them with plenty of cool water.
Note: If you use your fingers to apply makeup, the oils in your fingers will work to break down the makeup. The makeup will not last as long or provide a smooth even coverage.
WARNINGS: If you are sensitive to latex, discontinue use. Do NOT use around eye area. Do not ingest. Not intended as a food product. Not intended for children under 8 years of age. Do NOT get Zombie Rot into hair.
