Step I - Always start your makeup with a clean, dry face. If you need moisturizer under the makeup, make sure it is water-based type, as it will be absorbed in the skin faster and will not leave an oily coating on the face. If applying makeup to several people we recommend scooping a small amount of makeup out and putting it on a palette, this will help prevent the spread of germs.
Step 2 - Apply Spirit Gum to the underside of each Woochie appliance, taking care to cover the edges completely, so once adhered the edges don’t peel up.
Step 3 - Once the adhesive is applied to the piece, place the piece firmly onto the desired area. Remove the piece, lifting completely off the skin. Using the piece itself or your index finger, tack the adhesive using a rapid up and down motion. Continue until the Spirit Gum becomes matte or begins tugging the skin. The piece is now ready to apply. Press the piece firmly in place. Work a small amount of Spirit Gum under any unattached edges. Step 4 - For a more completely hidden edge, apply a thin coating of Flesh Latex over the edge with a makeup sponge using a patting motion. A few thin coats will work better than one thick coat. A hair dryer on low heat may be used to speed dry the Flesh Latex.
Step 5 - To use Burn Scar, first pour 2 or 3 tablespoons of hot water into one container, mixing to obtain an even texture. If material is too thick. slowly add more water to get an even pancake batter like texture.
Step 6 - Before applying, make sure mixture is not too hot for your face. Apply material using Wooden Stick provided, working from one section to the next. To create more texture, roughen up the surface as it begins to tack by using a stippling motion. The Black Stipple Sponge may also be used to create texture.
Step 7 - When the material is dry, seal it using Flesh Latex by patting on a thin layer with a makeup sponge. Let dry and pat on a second layer. Remember that two thin layers will dry faster than one thick layer. You can also pick holes in the latex for effect. FX Blood, Blood Gel or other liquid materials can be squeezed inside for a blister effect.
Step 8 - Now you are ready to add depth to your work by adding colors from your Injury Stack. Pat on corpse yellow to the high points of the effect. Next blend a mixture of bruised red and undead purple into the low points of the effect. Finally add black makeup here and there. Brushes my be used to detail areas if desired.
Step 9 - Using the Black Stipple Sponge, apply Cinema Secrets Blood Gel in a dragging motion across the face for a Road Rash effect. You can intensify any of the gore details by adding additional colors and blood as desired. Removal - To remove all makeup, use soap and warm water, however it is best to use the Cinema Secrets Makeup & Adhesive Remover. Put a small amount into your hand and using the pads of your fingertips, massage into makeup. Work in circular motions, being careful not to get any in your eyes or mouth. If some should get in your eyes, flush them with plenty of cool water.
Note: If you use your fingers to apply makeup, the oils in your fingers will work to break down the makeup. The makeup will not last as long or provide a smooth even coverage.
WARNINGS: If you are sensitive to latex, discontinue use. Do NOT use around eye area. Do not ingest. Not intended as a food product. Not intended for children under 8 years of age. Do NOT get Burn Scar into hair.